EnglishFrenchSpanish

OnWorks favicon

siglevdetcal - Online in the Cloud

Run siglevdetcal in OnWorks free hosting provider over Ubuntu Online, Fedora Online, Windows online emulator or MAC OS online emulator

This is the command siglevdetcal that can be run in the OnWorks free hosting provider using one of our multiple free online workstations such as Ubuntu Online, Fedora Online, Windows online emulator or MAC OS online emulator

PROGRAM:

NAME


siglevdetcal - The SvxLink signal level detector calibration utility

SYNOPSIS


siglevdetcal <configuration file> <RX config section name>

DESCRIPTION


siglevdetcal is the SvxLink signal level detector calibration utility. It is used to
assist in the setup of the SIGLEV_SLOPE and SIGLEV_OFFSET configuration variables for a
local receiver. The signal level detector need to be calibrated if a voter or the SIGLEV
squelch detector is going to be used.

The calibration procedure is quite simple and everything is more or less explained at run-
time. The procedure is outlined below.

· Disconnect the antenna and the PTT cable. The PTT might be triggered by the
siglevdetcal utility. If you want to be really sure that no harm come to your
transceiver, connect a dummy load.

· Setup the audio input level. The audio input level must not be changed after the
calibration has been done.

· Start the siglevdetcal utility.

· Transmit on another radio so that the receiver under calibration will receive
full signal strength.

· Still holding the PTT, press ENTER and wait until the squelch open level
measurements have been done.

· Release the PTT. Make sure the squelch is open so that only noise is received.

· Press ENTER to start the squelch close level measurements.

· When finished, the two config variables SIGLEV_SLOPE and SIGLEV_OFFSET are
printed. Put these in your configuration file under the corresponding receiver
configuration section.

· Start the SvxLink server and verify that full signal strength is showed as about
100 and open squelch is showed as about 0. If full signal strength is not showed,
you might have to setup SQL_DELAY to delay the signal level measurement until the
signal is stable.

ENVIRONMENT


ASYNC_AUDIO_NOTRIGGER
Set this environment variable to 1 if you get an error about ioctl: Broken pipe
when the remotetrx server starts.

Use siglevdetcal online using onworks.net services


Free Servers & Workstations

Download Windows & Linux apps

Linux commands

  • 1
    411toppm
    411toppm
    411toppm - convert Sony Mavica411 image
    to ppm ...
    Run 411toppm
  • 2
    a+
    a+
    Use a+ online using onworks.net
    services. ...
    Run a+
  • 3
    coresendmsg
    coresendmsg
    coresendmsg - send a CORE API message
    to the core-daemon daemon ...
    Run coresendmsg
  • 4
    core_server
    core_server
    core_server - The primary server for
    SpamBayes. DESCRIPTION: Currently serves
    the web interface only. Plugging in
    listeners for various protocols is TBD.
    This ...
    Run core_server
  • 5
    g.findfilegrass
    g.findfilegrass
    g.findfile - Searches for GRASS data
    base files and sets variables for the
    shell. KEYWORDS: general, map
    management, scripts ...
    Run g.findfilegrass
  • 6
    g.gisenvgrass
    g.gisenvgrass
    g.gisenv - Outputs and modifies the
    user�s current GRASS variable settings.
    Prints all defined GRASS variables if no
    option is given. KEYWORDS: general,
    settin...
    Run g.gisenvgrass
  • More »

Ad